Cassette Player and Recorder Dual Track |
This process uses a Dual Cassette Player and Recorder which is (Analog to Analog). This way is inexpensive, quick, simple and less prone to errors. Their is a BUT
You will need an Originally Recorded Cassette Tape.
Now you can program your Omnibot ® and have it work without a controller. You can take a pre-existing program tape and create a second tape to run your Omnibot ® Robot with new different conditions.
This process is not new, it has always been available but is a little used function. A whole world has re-opened for the Omnibot ® owners.
You can move into a world where audio tone, sequence and timing, with simple editing and recording, can be used to create new program tapes that will breath life into your Omnibot ® and let it become your stand alone Robot.
|
To program your robots you will need an original recorded cassette tape and a Dual Record and Play Cassette Player. Omnibot ® Controller Welcome! But Not Necessary. Use your Demo Cassette Program to check your Omnibot ® Robot and your Operating Programs to have it work without a controller.
The following are some of the recommendations to copy and create programed tapes. This has been successfully done but is not always 100% successful. Follow the recommendations and the steps and you should get the same results. (Remember different Robots and Cassette Recorders can act different.)
Please give feedback to improve these Recommendations and Files for the next user.
SOFTWARE- NONE IS NECESSARY
- Record from the original tape, stopping and starting the recorder, while you select from the original tape what you want to record. This will take some trial and setting until you get the experience.
- If you use software to monitor what you are doing, use State of the Art Recording Technology Software
- WavePad Recording Technology -
http://nch.com.au/wavepad/index.html&/orFreecorder Recording Technology - http://www.freecorder.com/READ THE INSTRUCTIONS AND INFORMATION THAT COMES WITH THIS SOFTWARE.If you are recording the Omnibot Mono tape, be sure to record in Mono mode.A recording made with a 44100 sampling rate will carry frequencies up to 20000 Hz.HARDWARE- A good Dual Mono or Stereo Cassette Player and Recorder.
- A high quality tape is necessary.
- The Omnibot ® Robot in good working condition.
PROCESS
- Cassette Player & Recorder - Hook up the cassette player and recorder, and test the process of recording between cassette tapes.
- Omnibot® Robot - Insert a cassette tape in the Omnibot® Robot and following the instructions (1) in that manual.
- Record and create a programmable tape. ( If you have a controller, if not get a tape from someone that can record and has a controller.)
- Record from the original tape, stopping and starting the recorder, while you select from the original tape what you want to record. This will take some trial and setting until you get the experience.
- Insert the programmed cassette into the Omnibot® robot and activate using the instructions (1) that come with the Omnibot ®
(1) Use and follow the instructions and procedures in the Omnibot ® 2000, Omnibot ® , Hearoid ® and Robie Sr. ® Operating Manuals to create your program tape.
There is no warranty expressed or implied with this procedure. By using any information from this web site, you agree not to hold responsible this site, me, nor any of its representatives, for any injuries and/or damages, both physical and/or psychological, that may arise from the use and/or misuse of anything derived from this site. The user further agrees that such information/pictures/software does not constitute any guarantee of accuracy, safety or reliability, and that cannot be held responsible for any way. This software is not supported. The user agrees to proceed at their own risk.
|
